FAQs
HOME > FAQs

How to Prolong The Service Life of Pellet Making Machine

In order to prolong the service life of pellet machine, we should find and solve the problems occurred in use in time. Find and solve the problems in time to ensure the service life of pellet making equipment and reduce unnecessary loss. Here, we share with you some preventive measures and solutions to the problem.

If there are axial or radial cracks on the pellets and the pulverization rate is high and the output is low, the reason for this phenomenon may be that the temperature-adjustable temperature is not reached or the maturation degree of the material is poor.

crack on pellets

In order to solve this problem, we should raise the tempering temperature and increase the amount of steam. It is also possible that the cutter is far away from the pellet and obtuse, causing the pellet to be short or torn rather than cut off.

The surface of the pellets is not smooth and the pulverization rate is high.

pellets without smooth surface

This may be caused by relatively small ring mode compression. The compression hole should be enlarged. The surface of the pellets is smooth, but the hardness is too high. This may be due to the large ring mode compression, the ring mode compression ratio should be reduced.

The production yield is low when the grain moisture content is high, and the phenomenon of blocking machine often occurs.

This may be due to the pressure relief valve can not play a decompression effect or the trap can not play a hydrophobic effect. The pressure-reducing valve should be adjusted so that the steam pressure into the regulator is 0.1-0.4 MPA, and so that the trap can play a hydrophobic effect. Also can increase the tempering temperature, because the temperature increase is conducive to the material maturation. When the general temperature rises by 11 ℃, the moisture content of the material increases by about 1%.

Pellets vary in length.

vary wood pellet length

The cutting distance should be adjusted or the deflection and scraping position should be adjusted. The tension of the belt of the two motors should be adjusted to make the tension as consistent as possible where the current deviation of the two motors is large. We should be careful when using pellet machines in order to prolong their life.

Choose wood pellet mill, please contact GEMCO, leave us messages for quotation and details. We are happy to give you free consultation no matter you purchase our machines or not. Thanks.

Get In touch Now!
Top
Scan to visit on mobile